GE Profile P2B940SEJSS Guide d'utilisation et d'entretien télécharger pdf (Page 19)

49-85222

USING THE OVEN: Oven Racks / Oven Air Vents

Oven Air Vents

Never block the vents (air openings) of the range. They

provide the air inlet and outlet that are necessary for the

range to keep cool and operate properly with correct

combustion.

Air openings are located at the rear of the cooktop, at

the top and bottom of the oven door, and at the bottom

of the range.

Vent appearance and location vary.

Oven Racks

Rack Positions

Your oven has six rack positions in the main oven.

Recommended rack positions for various types of

foods are provided in the Cooking Guide. Adjusting

the rack position is one way to impact cooking results.

For example, if you would prefer darker tops on cakes,

muffins or cookies, try moving food one rack position

higher. If you find foods are too brown on top, try moving

them down next time.

When baking with multiple pans and on multiple racks,

ensure there is sufficient space between pans to allow

air to flow. This may improve cooking evenness.

Removing and Replacing Flat Racks

When placing and removing cookware, pull the rack out

to the bump (stop position) on the rack support.

To remove a rack, pull it toward you until it reaches the

stop position, tilt up the front of the rack and pull it out.

To replace a rack, place the curved end of the rack onto

the rack supports. Tilt up the front of the rack and push

the rack in until it stops. Then lay the rack flat and push

it in until it is all the way into the oven.

Racks may become difficult to slide, especially after a

self-clean cycle. To improve sliding conditions, use a soft

cloth or paper towel to rub vegetable oil on the left and

ULJKWHGJHVRIWKHUDFNVDQGRUUDFNVXSSRUWV

NOTE: Remove unused racks when using the oven for

faster preheat, improved efficiency, and optimal cooking

performance.

Extension Racks (on some models)

Extension racks have a frame that locks into the rack

supports on both sides. Once the frame is locked into place,

always use the upper front rail to pull the rack out to its full

extension position when placing or removing cookware.

If extension racks are difficult to extend, lubricate the

racks with the graphite lubricant provided with your oven.

Remove the rack from the oven (see Extension Rack

Removal), remove debris in the slide tracks with a paper

towel, shake the graphite lubricant, and place 4 small drops

on the two bottom tracks of the left and right sides. Open

and close the rack several times to distribute the lubricant.

6HHWKH$VVLVWDQFH$FFHVVRULHVVHFWLRQIRULQVWUXFWLRQVRQ

ordering additional racks and graphite lubricant.

Extension Rack Removal

1. Make sure the rack is pushed all the way into the oven.

2. Firmly holding onto both the upper and lower front

rails, pull the rack toward you, tilt the front end up and

pull the rack out.

Extension Rack Replacement

1. Place the curved end of the rack onto the rack supports.

2. Tilt up the front of the rack and push the rack in until

it stops.

/D\WKHUDFNIODWDQGSXVKLWLQXQWLOLWLVDOOWKHZD\

into the oven.

If extension racks are difficult to replace or remove, wipe

the oven rack supports with cooking oil. Do not wipe oil

on the rack slides.

Rack positions

Removing racks

Replacing racks

Rack stop

position

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

GE Profile P2B940SEJSS Guide d'utilisation et d'entretien Page 19

Commentaires sur ces manuels

Produits connexes et manuels pour Non GE Profile P2B940SEJSS